Steel Hose Tail

The Adjustable Pressure Relief Valve is to be installed to complement pumps that have no internal bypass valve. The adjustable valve is designed to relieve excess liquid pressure back to the tank for applications requiring a nozzle to be used. Pressure gauges should be installed on the inlet to set the opening pressure for the pumping system.

Not to be used as a bypass recirculation system under constant pressure.

This Stainless Steel Solenoid Valve is a direct acting valve, meaning that no pressure has to be applied to operate, suitable for a range of fluids including AdBlue™, fuels, oil and water. As a normally closed solenoid valve, the liquid flow is shut off until the valve is activated. When the coil integral to the valve becomes energised by an electrical current, the valve opens to enable the flow of liquid through the pipeline.

This stainless steel solenoid valve is therefore designed for situations where the fluid only needs to be released at certain intervals, for example to feed a generator with fuel from the back up storage tank. The valve could also be wired into a pump to make sure that fluid only enters the pipework from the tank when the pump is activated.

The H Series Compatible Quick Release Couplings are general purpose, plated steel hose couplings. They instantly seal upon disconnection to prevent any leakages, and benefit from a smooth jet valve design with a safety pin system to prevent the accidental disconnection of the quick release couplings. The coupler and nipple are sold separately, and are compatible with Snap-Tite H and US-MIL-C-51234.

The SAMOA Polaris Series transfer Pump is a self priming diesel pump with self-adjustable vanes, Pump body made of cast-iron with rustproof treatment, rotor of sintered steel and vanes of acetal resin. The pumps include a by-pass valve and a built in filter with easy access for cleaning.  The pump can be mounted vertically or horizontally and has 1.8m cable with plug.

Comes wih -

230v 50z Polaris 70 Transfer Pump

4 Metre Delivery Hose

Dispensing Nozzle (Manual or Automatic options)

Fittings

Inlet/outlet connection: 1" BSP (F) or flange coupling

Maximum suction lift: 2.5m

Pressure: 1.7 bar

230v - 50hz - 3 amp - 500 watt

Electric AC motor with IP55 protection, allow continuous operation duty.

On/off switch and fuse.